Article ID: 252713
Article Last Modified on 5/10/2004
APPLIES TO
- Microsoft BackOffice Small Business Server 4.0
- Microsoft BackOffice Small Business Server 4.0a
- Microsoft BackOffice Small Business Server 4.5
This article was previously published under Q252713
SUMMARY
This article describes how to properly configure the binding order on a Small Business Server-based computer. Having bindings improperly configured can lead to a number of connectivity and program errors. When you make changes to the network configuration (such as adding protocols, adapters, modems, or services), the binding order can potentially change. Check the binding order whenever you make changes to the network configuration.
A partial list of issues that are resolved by properly configuring the network binding order includes:
133031 Event ID 4280 appears for WINS bound to one NIC
189848 Computers disappear from Manage Computer Wizard in Small Business Server
219364 DHCP disabled when connected to Internet Service Provider
224800 SBS 4.5 Setup does not automatically detect 8255x Intel network adapters
236034 "The Page Cannot Be Displayed" error message when attempting to open the SBS console
237773 How to configure SBS/BOS for a static connection to the Internet with proxy
238167 How to configure and troubleshoot Small Business Server
244223 Troubleshooting and resolving Web proxy event ID 127
252722 Microsoft Exchange Connector for POP3 mailboxes installation is unsuccessful with "Extension 'IMBSBS' Could Not Load" error message
279415 MSEXCHANGEMTA 9321 error message occurs when you try to start the Message Transfer Agent
MORE INFORMATION
To configure the network binding order:
- Quit any programs that are running.
- Right-click Network Neighborhood, and then click Properties.
- Click the Bindings tab. In the Show Bindings For box, click All Services.
- Double-click each listed service to expand it.
- Under each service, double-click each protocol to expand it.
- Under each protocol, there is a number of network adapter icons. Click the icon for your network adapter, and then click Move Up until the network adapter is at the top of the list. Leave the "Remote Access WAN Wrapper" entries in any order under the network adapter(s).
Note If you have more than one network adapter, place the internal adapter (with Internet Protocol [IP] address 10.0.0.2 by default on a Small Business Server network) at the top of the binding order, with the external adapter(s) directly below the internal adapter.
The final order should appear similar to:[1] Network adapter one
[2] Network adapter two (if present)
[3] Remote Access WAN Wrapper
.
.
.
[n
] Remote Access WAN Wrapper - Repeat step 6 for each service in the dialog box.
- After you have verified the settings for each service, click All Protocols in the Show Bindings For box. The entry for "Remote Access WAN Wrapper" does not have a network adapter listed. Skip this item. Repeat steps 4 through 6 for each remaining protocol.
- After you have verified that the bindings are set correctly for all services and protocols, click OK. This initializes the rebinding of the services. When this is complete, you are prompted to restart the computer. Click Yes.
Additional query words: smallbiz sbs
Keywords: kbhowto kbenv kbnetwork KB252713