Microsoft KB Archive/247252: Difference between revisions
(importing KB archive) |
m (Text replacement - """ to """) |
||
Line 45: | Line 45: | ||
When you try to create a queued component using the following format | When you try to create a queued component using the following format | ||
<pre class="codesample"> Set oMyObject = GetObject( | <pre class="codesample"> Set oMyObject = GetObject("queue:/new:EjezServer.CMyClass") | ||
</pre> | </pre> | ||
you may receive this error message: | you may receive this error message: | ||
Line 92: | Line 92: | ||
# Configure an object in a COM+ application, or choose an object that is not configured in a COM+ Application. | # Configure an object in a COM+ application, or choose an object that is not configured in a COM+ Application. | ||
# Make sure that the application is not marked as queued in the '''Queuing''' tab of its property sheet. | # Make sure that the application is not marked as queued in the '''Queuing''' tab of its property sheet. | ||
# Attempt to get an instance of the queued component using the queue moniker. You receive the error described in the | # Attempt to get an instance of the queued component using the queue moniker. You receive the error described in the "Symptoms" section. | ||
Latest revision as of 13:50, 21 July 2020
Article ID: 247252
Article Last Modified on 10/22/2000
APPLIES TO
- Microsoft COM+ 1.0
This article was previously published under Q247252
SYMPTOMS
When you try to create a queued component using the following format
Set oMyObject = GetObject("queue:/new:EjezServer.CMyClass")
you may receive this error message:
CAUSE
The component is not configured in a COM+ application with the requested interface marked as queued.
RESOLUTION
Mark the application as queued by following the directions in this article:
246825 HOWTO: Configuring a COM+ application for Queued Components
STATUS
This behavior is by design. The error message is a warning of a wrong configuration.
MORE INFORMATION
Steps to Reproduce Behavior
- Configure an object in a COM+ application, or choose an object that is not configured in a COM+ Application.
- Make sure that the application is not marked as queued in the Queuing tab of its property sheet.
- Attempt to get an instance of the queued component using the queue moniker. You receive the error described in the "Symptoms" section.
REFERENCES
- For additional information, click the article number below to view the article in the Microsoft Knowledge Base:
246825 HOWTO: Configuring a COM+ application for Queued Components
- See the Queued Components documentation on MSDN for more detailed information on queued components and related COM+ version 1.0 services.
Additional query words: Run-time error -2146368000 80110600 Automation COM+ applications marked queued queue moniker
Keywords: kbcomplusqc kbprb KB247252