Microsoft KB Archive/175580: Difference between revisions
m (Text replacement - """ to """) |
m (Text replacement - "&" to "&") |
||
Line 69: | Line 69: | ||
<pre class="codesample"> begin 660 test.txt | <pre class="codesample"> begin 660 test.txt | ||
%=& | %=&5S= H XXXX | ||
end | end | ||
</pre> | </pre> |
Latest revision as of 12:30, 21 July 2020
Article ID: 175580
Article Last Modified on 10/28/2006
APPLIES TO
- Microsoft Exchange Server 5.0 Standard Edition
This article was previously published under Q175580
SYMPTOMS
When a message is received by Microsoft Exchange Server version 5.0 from Softswitch, the Microsoft Exchange Internet Mail Service will deliver the message correctly. However, when a Microsoft Exchange Client opens the message, the following error message will be displayed:
CAUSE
The uuencode algorithm starts each line with a character to signify how many characters of that line are to be decoded. Here is an example:
begin 660 test.txt %=&5S= H XXXX end
The "%" is the ascii representation of 0x25. The uudecode algorithm then
- Subtracts 0x20, leaving 0x05.
- Divides by 3.
- Rounds up.
- Multiplies by 4.
to get 8, the number of characters to decode in the line. The line displayed above has 12 characters (plus the length character). Uudecode should not have a problem with this as it should stop decoding that line at column 13.
STATUS
Microsoft has confirmed this to be a problem in Microsoft Exchange Server, version 5.0.
A supported fix is now available, but has not been fully regression-tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the next Service Pack that contains this fix. Contact Microsoft Technical Support for more information.
Keywords: kbhotfixserver kbqfe kb3rdparty kbbug kbfix kbqfe KB175580