Microsoft KB Archive/169965: Difference between revisions
m (Text replacement - ">" to ">") |
m (Text replacement - """ to """) |
||
| Line 39: | Line 39: | ||
<ol> | <ol> | ||
<li>Restart the computer. Press the F8 key when you see the | <li>Restart the computer. Press the F8 key when you see the "Starting Windows 95" message, and then choose Safe Mode Command Prompt Only from the Startup menu.</li> | ||
<li><p>At the command prompt, type the following lines, pressing ENTER after each line:</p> | <li><p>At the command prompt, type the following lines, pressing ENTER after each line:</p> | ||
<blockquote>'''cd windows<br /> | <blockquote>'''cd windows<br /> | ||
edit system.ini'''</blockquote></li> | edit system.ini'''</blockquote></li> | ||
<li><p>Locate and disable any lines that refer to | <li><p>Locate and disable any lines that refer to "Tranxit" in the [386enh] section by placing a semicolon (;) at the beginning of the line. For example, disable the following lines:</p> | ||
<blockquote>'''Drivers added for Tranxit<br /> | <blockquote>'''Drivers added for Tranxit<br /> | ||
device=c:\tranxit\<driver_name>.386'''</blockquote></li> | device=c:\tranxit\<driver_name>.386'''</blockquote></li> | ||
Latest revision as of 11:04, 21 July 2020
Toshiba 500CS 500CDT, or 730 Computer Hangs on First Reboot |
Q169965
The information in this article applies to:
- Microsoft Windows 95
SYMPTOMS
The first time you boot a new Toshiba 500CS, 500CDT, or 730 laptop computer, you have the option to install Windows 3.1 or Windows 95. If you choose to install Windows 95, Windows 95 Setup may stop responding (hang) on the first reboot. Windows 95 Setup must reboot the computer to finish the installation.
CAUSE
This behavior can occur if the real-mode drivers for the Xircom IIPS PCMCIA Ethernet card are installed on the computer.
RESOLUTION
Disable the real-mode drivers by following these steps:
- Restart the computer. Press the F8 key when you see the "Starting Windows 95" message, and then choose Safe Mode Command Prompt Only from the Startup menu.
At the command prompt, type the following lines, pressing ENTER after each line:
cd windows
edit system.iniLocate and disable any lines that refer to "Tranxit" in the [386enh] section by placing a semicolon (;) at the beginning of the line. For example, disable the following lines:
Drivers added for Tranxit
device=c:\tranxit\<driver_name>.386- Save and then close the System.ini file.
- Restart your computer normally.
MORE INFORMATION
For additional information, please contact Toshiba, Inc.
Keywords : kb3rdparty kbhw kbsetup win95
Issue type :
Technology : kbWin95search kbWin95
Last Reviewed: December 15, 2000 |
