Microsoft KB Archive/110923: Difference between revisions
(importing KB archive) |
m (Text replacement - """ to """) |
||
| Line 52: | Line 52: | ||
When these NDIS 2 drivers are loaded with Windows for Workgroups 3.11, they are loaded on the transport= line of the SYSTEM.INI file. To pass the DRIVER=NDIS parameter to CECFG.EXE, add the following line to the [network drivers] section of the SYSTEM.INI file: | When these NDIS 2 drivers are loaded with Windows for Workgroups 3.11, they are loaded on the transport= line of the SYSTEM.INI file. To pass the DRIVER=NDIS parameter to CECFG.EXE, add the following line to the [network drivers] section of the SYSTEM.INI file: | ||
<pre class="codesample"> [network drivers] | <pre class="codesample"> [network drivers] | ||
CECFG.EXE= | CECFG.EXE="Driver=NDIS" | ||
</pre> | </pre> | ||
Latest revision as of 11:09, 20 July 2020
Article ID: 110923
Article Last Modified on 10/6/1999
APPLIES TO
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q110923
SUMMARY
When you use Windows for Workgroups 3.11 with certain NDIS 2 network adapter drivers, you must specify command-line parameters to make these drivers load correctly. These parameters can be added by editing the SYSTEM.INI file with a text editor such as Microsoft Windows Notepad.
Below is an example in which the real-mode drivers for a Xircom credit card adapter are loaded in the AUTOEXEC.BAT file:
CECFG DRIVER=NDIS
CENDIS
When these NDIS 2 drivers are loaded with Windows for Workgroups 3.11, they are loaded on the transport= line of the SYSTEM.INI file. To pass the DRIVER=NDIS parameter to CECFG.EXE, add the following line to the [network drivers] section of the SYSTEM.INI file:
[network drivers]
CECFG.EXE="Driver=NDIS"
Additional query words: 3.11 ndis2 cmd line
Keywords: KB110923
