Microsoft KB Archive/108808: Difference between revisions
(importing KB archive) |
m (Text replacement - """ to """) |
||
Line 73: | Line 73: | ||
</div> | </div> | ||
NOTE: This error can also occur when | NOTE: This error can also occur when "net start" is not in the AUTOEXEC.BAT file or NET.EXE is corrupted. You can also receive this error message if IFSHLP.SYS is not loaded or you start Windows for Workgroups 3.11 with the /N switch. | ||
</div> | </div> |
Latest revision as of 10:25, 20 July 2020
Article ID: 108808
Article Last Modified on 10/7/1999
APPLIES TO
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q108808
SYMPTOMS
When you start the Remote Access Services (RAS) client program for Windows for Workgroups version 3.11, the following error message is displayed:
-or-
If you try to start RAS a second time after you receive the general protection (GP) fault, the following error message is displayed:
NOTE: This error can also occur when "net start" is not in the AUTOEXEC.BAT file or NET.EXE is corrupted. You can also receive this error message if IFSHLP.SYS is not loaded or you start Windows for Workgroups 3.11 with the /N switch.
CAUSE
These errors are caused either by a missing or corrupted SERIAL.INI file, or by blank lines at the beginning of the SERIAL.INI file. This file is in the Windows directory. Error 714 generally occurs when the SERIAL.INI file is missing; the GP fault occurs if the SERIAL.INI file is corrupted.
The SERIAL.INI file is used to store the configuration information for the RAS client program.
RESOLUTION
To correct this problem, re-create the SERIAL.INI file as follows:
- In the Network group, start Network Setup.
- Choose the Drivers button.
- Select Remote Access Service [NDIS3] and then choose the Setup button.
- Select the appropriate device for the COM port you will be using.
- Choose the OK button, then exit Network Setup.
Additional query words: 3.11
Keywords: kbenv KB108808