Microsoft KB Archive/108750: Difference between revisions
From BetaArchive Wiki
(importing KB archive) |
m (Text replacement - """ to """) |
||
Line 12: | Line 12: | ||
<div id="TitleRow"> | <div id="TitleRow"> | ||
= <span id="KB108750"></span>You Must Use | = <span id="KB108750"></span>You Must Use "DBLSPACE /FORMAT A: " to Format That Drive = | ||
Line 47: | Line 47: | ||
<div class="errormessage"> | <div class="errormessage"> | ||
You must use | You must use "DBLSPACE /FORMAT <X>:" to format that drive. | ||
</div> | </div> |
Revision as of 10:25, 20 July 2020
Article ID: 108750
Article Last Modified on 11/18/1999
APPLIES TO
- Microsoft MS-DOS 6.2 Standard Edition
This article was previously published under Q108750
SYMPTOMS
If you unmount a compressed volume file (CVF) on a floppy disk drive and then try to use the MS-DOS FORMAT command to format a floppy disk, you may receive the following message
where <X> is the floppy disk drive letter.
CAUSE
This message is caused by the new Automount feature in MS-DOS 6.2. Any command that attempts to access a floppy disk drive containing a disk with a CVF mounts that CVF.
RESOLUTION
To work around this problem:
- Change to the drive letter that contains the compressed floppy disk (usually A: or B:) by typing A: or B:.
- Type dblspace /unmount <x>: where <x> is the floppy disk drive letter.
- Type format <x>: where <x> is the floppy disk drive letter.
Additional query words: 6.20
Keywords: KB108750