Difference between revisions of "Microsoft KB Archive/107995"

From BetaArchive Wiki
m (Text replacement - "<" to "<")
m (Text replacement - "&" to "&")
 
(One intermediate revision by the same user not shown)
Line 12: Line 12:
 
<div id="TitleRow">
 
<div id="TitleRow">
  
= <span id="KB107995"></span>NDIS2 Drivers Load but NDIS3 Drivers Don't--Errors 6200 &amp; 58 =
+
= <span id="KB107995"></span>NDIS2 Drivers Load but NDIS3 Drivers Don't--Errors 6200 & 58 =
  
  
Line 47: Line 47:
 
<div class="errormessage">
 
<div class="errormessage">
  
Error 6200: Adapter <adapter-name&gt; not found
+
Error 6200: Adapter <adapter-name> not found
  
 
</div>
 
</div>

Latest revision as of 11:25, 21 July 2020

Knowledge Base


Article ID: 107995

Article Last Modified on 9/24/1999



APPLIES TO

  • Microsoft Windows for Workgroups 3.11



This article was previously published under Q107995

SYMPTOMS

When you start Windows for Workgroups, you may receive one of the following error messages:

Error 6200: Adapter <adapter-name> not found

-or-


Error 58: The network has responded incorrectly

NOTE: These errors usually occur in protected mode; real-mode networking usually loads correctly.

CAUSE

The above error messages may be caused by an incorrect I/O base address, an incorrect RAM address, or an improper IRQ setting in the PROTOCOL.INI file.

These errors may be generated if the Transport= line in the [386Enh] section of the SYSTEM.INI contains protocols that are not in use. For example, if the Transport= line contains the following

     Transport=netbeui.386,nwlink.386,nwnblink.386
                

but the only protocol in use is NetBeui, the errors may occur.

RESOLUTION

Correct the invalid setting.

If the Transport= line contains invalid references, remove them (that is, remove the references to nwlink.386, nwnblink.386, and IPX/SPX compatible transport).

MORE INFORMATION

The NDIS2 network interface card (NIC) driver may not rely on the PROTOCOL.INI settings; however, the NDIS3 NIC driver relies almost exclusively on these settings.


Additional query words: 3.11 error message err msg enhanced mode protect NDIS tshoot

Keywords: KB107995