Microsoft KB Archive/103529: Difference between revisions
m (Text replacement - "<" to "<") |
m (Text replacement - ">" to ">") |
||
Line 50: | Line 50: | ||
<div class="errormessage"> | <div class="errormessage"> | ||
You must use "DBLSPACE /FORMAT <drive | You must use "DBLSPACE /FORMAT <drive>:" to format that drive | ||
</div> | </div> |
Latest revision as of 10:17, 20 July 2020
Article ID: 103529
Article Last Modified on 11/22/1999
APPLIES TO
- Microsoft MS-DOS 6.2 Standard Edition
- Microsoft MS-DOS 6.22 Standard Edition
This article was previously published under Q103529
SYMPTOMS
This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames.
When you format a floppy disk, DoubleSpace may fail to give you the following error message:
As a result, you have a freshly formatted non-DoubleSpace-compressed disk.
CAUSE
This problem occurs if you access an uncompressed floppy disk (for example, DIR A:), remove the uncompressed floppy, insert a compressed floppy, and attempt to format it. In this situation, the DoubleSpace Automount code is never called, and the DoubleSpace-compressed floppy disk is not mounted.
NOTE: This problem may also occur if the Automount feature has been disabled.
RESOLUTION
If you have already formatted a DoubleSpace-compressed floppy disk, recompress the disk with the DBLSPACE /COMPRESS command.
To prevent this problem, access the DoubleSpace-compressed floppy disks before formatting them. For example, type the following at the MS-DOS command prompt, pressing ENTER after each line:
a:
format a:
Additional query words: 6.20 auto mount auto-mount dblspace double space
Keywords: KB103529