Article ID: 100795
Article Last Modified on 11/21/1999
APPLIES TO
- Microsoft MS-DOS 6.0 Standard Edition
This article was previously published under Q100795
SYMPTOMS
If you have a command in your CONFIG.SYS file that contains the at sign (@), you receive the following error message when you run MemMaker:
Since the at sign is a valid parameter for the Corel SCSI and STAC Electronics Stacker device drivers, you may receive the above error message if you run MemMaker and have either of these drivers loaded.
CAUSE
MemMaker version 6.0 does not accept the at sign as a valid command parameter.
WORKAROUND
To work around this problem, either use "REM" to remark out the command line containing the at sign or remove the at sign parameter from the command line before you run MemMaker.
STATUS
Microsoft has confirmed this to be a problem in Microsoft MS-DOS MemMaker version 6.0. This problem was corrected in MS-DOS version 6.2.
Additional query words: 6 lantasti redir options switch 4dos stacker express custom mode command.com symbol
Keywords: KB100795