Article ID: 125932
Article Last Modified on 11/1/2006
APPLIES TO
- Microsoft Windows NT Advanced Server 3.1
- Microsoft Windows NT Workstation 3.1
- Microsoft Windows NT Advanced Server 3.1
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Server 3.5
This article was previously published under Q125932
SYMPTOMS
In Windows NT Help, if you select Command Reference Help (NTCMDS.HLP) and choose CACLS, the /P switch lists the following permission (perm) options:
n - None r - Read c - Change (write) a - All permissions
However, if you specify perm "a" with the CACLS command, the following error message appears:
CAUSE
The Command Reference Help file references the permission options of the CACLS command incorrectly.
WORKAROUND
The perm options should show as the following:
n - None r - Read c - Change (write) f - Full control
NOTE: The correct perm options can be viewed by typing the following at the MS-DOS Command Prompt:
CACLS /H
STATUS
Microsoft has confirmed this to be a problem in Windows NT versions 3.1 and 3.5. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
Additional query words: prodnt 3.10 winhlp32
Keywords: KB125932