User:Dans34/Sandbox/arduino: Difference between revisions
From BetaArchive Wiki
< User:Dans34 | Sandbox
m (→To Do) |
m (→To Do) |
||
Line 11: | Line 11: | ||
: <s>Connections to be made to Com & N/o (N/C is connected when pin is LOW)</s>- 21/7/11 used old floppy drive power cable and molex | : <s>Connections to be made to Com & N/o (N/C is connected when pin is LOW)</s>- 21/7/11 used old floppy drive power cable and molex | ||
:Set pin HIGH to turn ON relay , pin LOW to turn OFF | :Set pin HIGH to turn ON relay , pin LOW to turn OFF | ||
: <s>Run standard timed relay test code, on for 1s, off for 1s</s> -21/7/11 , | : <s>Run standard timed relay test code, on for 1s, off for 1s</s> -21/7/11 , surprised at the build quality, no solder splashes and everything fits in the headers | ||
;Motor shield | ;Motor shield | ||
: Again run standard motor tests | : Again run standard motor tests | ||
;Intergrate relay and motor shield code | ;Intergrate relay and motor shield code | ||
;Camera | |||
:Create Roof rack for camera (use old caddy from sun server) | |||
: Mount Wireless Video Transmitter | |||
: BNC(camera) to RCA(transmitter) converter | |||
: Step up 7.4v to 12v for camera | |||
: Step up 7.4v to 9v for transmitter | |||
: ( or will it be better to step down 12v to 9v & 12v to 5V (for arduino) ?? ) |
Revision as of 11:06, 22 July 2011
Nothing to do with beta's here , just my arduino scratchpad
RC 1/14 Scale Range Rover
To Do
Create arduino basic framework code (define pin I/O)- 21/7/11- Bluetooth RS232 module
- Connect Bluetooth RS232 module to pins 0(RX) , 1 (TX) ,+5v(power) , GND
- Solder in headers ontop of relay shield for better access to pins
- Relay Shield
Connections to be made to Com & N/o (N/C is connected when pin is LOW)- 21/7/11 used old floppy drive power cable and molex- Set pin HIGH to turn ON relay , pin LOW to turn OFF
Run standard timed relay test code, on for 1s, off for 1s-21/7/11 , surprised at the build quality, no solder splashes and everything fits in the headers- Motor shield
- Again run standard motor tests
- Intergrate relay and motor shield code
- Camera
- Create Roof rack for camera (use old caddy from sun server)
- Mount Wireless Video Transmitter
- BNC(camera) to RCA(transmitter) converter
- Step up 7.4v to 12v for camera
- Step up 7.4v to 9v for transmitter
- ( or will it be better to step down 12v to 9v & 12v to 5V (for arduino) ?? )