Article ID: 94363
Article Last Modified on 10/13/2003
APPLIES TO
- Microsoft Windows for Workgroups 3.1
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q94363
SYMPTOMS
The following error message may occur during startup if the SMC_ARC.DOS driver is being used:
This error indicates that the system board is being detected as a PS/2 board even though it is an ISA or EISA board.
WORKAROUND
To work around the problem, edit the MAC driver section (example: [MS$SMC270])of the Windows for Workgroups PROTOCOL.INI file adding the following line:
Micro_Channel=0
Here is an example of how the section reads:
[MS$SMC270] DriverName=SMC_ARC$ interrupt=2 iobase=0x2E0 memorybase=0xD000 MICRO_CHANNEL=0
WARNING: When editing the PROTOCOL.INI file manually, always remember that modifications made with the Network settings in Control Panel may result in the loss of any manual editing. Therefore, it may be necessary to add this entry again after modifying settings through Control Panel.
Additional query words: 3.1 3.10 ps2 micro channel err msg boot process bootup start up
Keywords: KB94363