Article ID: 81790
Article Last Modified on 5/12/2003
APPLIES TO
- Microsoft MS-DOS 3.1
- Microsoft MS-DOS 3.2 Standard Edition
- Microsoft MS-DOS 3.21 Standard Edition
- Microsoft MS-DOS 3.3 Standard Edition
- Microsoft MS-DOS 3.3a
- Microsoft MS-DOS 4.0 Standard Edition
- Microsoft MS-DOS 4.01 Standard Edition
- Microsoft MS-DOS 5.0 Standard Edition
- Microsoft MS-DOS 5.0a
- Microsoft MS-DOS 6.0 Standard Edition
- Microsoft MS-DOS 6.2 Standard Edition
- Microsoft MS-DOS 6.21 Standard Edition
- Microsoft MS-DOS 6.22 Standard Edition
This article was previously published under Q81790
SUMMARY
This articles describes the following error messages that you may receive when you run Lotus 1-2-3 release 3.1:
MORE INFORMATION
VM ERROR [6]: INTERNAL ERROR
According to Lotus technical support, if your CONFIG.SYS file contains only HIMEM.SYS and DOS=HIGH, the error message
may be displayed when shelling out from 1-2-3 release 3.1 using /SYSTEM. You may be able to work around the problem by including the following lines in your CONFIG.SYS file
files=X
buffers=X
device=c:\dos\himem.sys
device=c:\dos\emm386.exe nnn ram
dos=high,umb
(where nnn is the amount of expanded memory).
If the error occurs on an 80286 machine, do not load MS-DOS high.
VM ERROR [19]: Not Enough Memory to Start 1-2-3
If the error message
-or-
is displayed when starting Lotus 1-2-3 release 3.1, there is not enough extended memory to start 1-2-3.
1-2-3 release 3.1 requires a minimum of 384K of free extended memory to run; when the minimum is not available, one of the above error messages may be displayed when starting 1-2-3.
The Lotus product included here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Additional query words: 6.22 3.0 3.00 3.1 3.10 3.2 3.20 3.21 3.22 3.3 3.3a 3.30 3.30a 4.0 4.00 4.0a 4.00a 4.01 4.01a 5.00 5.00a 6.00 6.20
Keywords: KB81790
