Article ID: 78023
Article Last Modified on 11/16/2006
APPLIES TO
- Microsoft Money 2004 Deluxe Edition
- Microsoft Money 2003 Standard Edition
- Microsoft Money 2002 Standard Edition
- Microsoft Money 2001 Standard Edition
- Microsoft Money 2000 Standard Edition
- Microsoft Money 99 Standard Edition
- Microsoft Money 98 Standard Edition
- Microsoft Money 97 Standard Edition
- Microsoft Money 2000 Business & Personal Edition
- Microsoft Money 98 Deluxe Edition
- Microsoft Money 98 Financial Suite Edition
This article was previously published under Q78023
SYMPTOMS
When you try to print checks to a laser printer in Microsoft Money, you may receive a message that states that the print is finished, even if the checks are not printed.
You may also experience these symptoms when you attempt to run a print test from the Print Checks dialog box. However, when you print a report, the report is printed properly.
In addition, if you use Money 99 or later, you may receive the following error message:
CAUSE
This behavior can occur if you select Standard, Voucher, or Wallet checks in the Print Setup dialog box in Money, and then attempt to print your checks to a laser printer.
Continuous-feed checks are designed for dot-matrix printers.
RESOLUTION
To prevent this issue from occurring, use only single-sheet checks when you print checks to a laser printer.
If you print checks to a dot-matrix printer, use continuous-feed checks.
Note The default check type in Money 3.0 is Standard, which is a continuous-feed type of check. If you want to print checks to a laser printer, you must select either Laser Standard, Laser Voucher, or Laser Wallet checks in the Print Setup dialog box in Money.
Additional query words: w_money 97 6.0 7.0 8.0 planet money2k m2001
Keywords: kberrmsg kbprb kbprint KB78023
