Article ID: 72482
Article Last Modified on 11/19/2003
APPLIES TO
- Microsoft Macro Assembler 6.0 Standard Edition
- Microsoft Macro Assembler 6.0a
- Microsoft Macro Assembler 6.0b
This article was previously published under Q72482
SYMPTOMS
The Microsoft Macro Assembler (MASM) versions 6.0, 6.0a, and 6.0b may generate the following error if a large module is assembled with /Zi to generate CodeView symbolic information:
CAUSE
If you are not near the 64K limit in code or data, it is possible that the $$SYMBOL segment created for CodeView's symbolic information has grown too large.
RESOLUTION
If you require full symbolic information, the only workaround is to split the module up into smaller files and reassemble. If you only need line numbers to debug this module, you can use the /Zd (generate line numbers) switch as a workaround.
STATUS
Microsoft has confirmed this to be a problem in MASM versions 6.0, 6.0a, and 6.0b. This problem was corrected in MASM for MS-DOS version 6.1.
MORE INFORMATION
Note that the A2103 error may occur even when your source module is defined with the ".386" and ".MODEL flat" directives because MASM version 6.0 always defines the $$SYMBOL segment as a 16-bit segment.
Additional query words: 6.00 6.00a 6.00b buglist6.00 buglist6.00a buglist6.00b fixlist6.10
Keywords: kbfix KB72482
