Article ID: 49739
Article Last Modified on 11/26/2003
APPLIES TO
- Microsoft MS-DOS 3.1
- Microsoft MS-DOS 3.2 Standard Edition
- Microsoft MS-DOS 3.21 Standard Edition
- Microsoft MS-DOS 3.3 Standard Edition
- Microsoft MS-DOS 3.3a
- Microsoft MS-DOS 4.0 Standard Edition
- Microsoft MS-DOS 4.01 Standard Edition
- Microsoft MS-DOS 5.0 Standard Edition
This article was previously published under Q49739
SUMMARY
ASSIGN does not check the current name for the disk drive; instead, it retains the "true", original name of the disk drive for reassignment.
If floppy disk Drive A contains a single file named A.TXT and floppy disk Drive B contains a single file named B.TXT, the following commands cause the file B.TXT to be displayed in the directory:
C> ASSIGN A=B
C> DIR A:
The syntax documentation for the ASSIGN command can be checked to verify that this is what should happen. The first drive specified is the drive that MS-DOS normally reads and writes to. The second is the drive that you want MS-DOS to read and write to when the first drive is referenced.
It is not quite so intuitive how to restore A to A and B to B. The following example demonstrates how to ASSIGN the drive back to itself:
C> ASSIGN A=A
After this command is issued, a DIRectory of Drive A displays the file A.TXT.
Additional query words: 3.20 3.21 3.30 3.30a 4.00 4.01 5.00
Keywords: KB49739
