Microsoft KB Archive/313069

From BetaArchive Wiki
Knowledge Base


Article ID: 313069

Article Last Modified on 2/28/2007



APPLIES TO

  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • Microsoft Windows 2000 Professional Edition



This article was previously published under Q313069

SYMPTOMS

When you attempt to run Riprep.exe from a Windows 2000-based Remote Installation Service (RIS) server on an Windows XP-based client computer to create an image, you may receive the following error message:

Riprep.exe - entry point not found

The Procedure entry point EnablePrivilege could not be located in the dynamic library Setupapi.dll

CAUSE

This problem occurs because Riprep.exe cannot create or deploy Windows XP images.

RESOLUTION


Microsoft has released an update that permits Riprep.exe to create and deploy Windows XP images across a Windows 2000 RIS server. To install the update, click the following link:

When you use this update, you should also install the update that is described in the following Microsoft Knowledge Base article:

308508 Windows 2000 Server images not available on Windows 2000 RIS server



When you install the update, the binaries are updated. After the binaries are updated, you can run Riprep on computers that are running either Windows 2000 Server or Windows 2000 Advanced Server.

IMPORTANT: If you use Riprep on computers that are running either Windows 2000 Server or Windows 2000 Advanced Server, Riprep is not supported by Microsoft.


STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

Keywords: kbhotfixserver kbqfe kbbug kbfix kbqfe KB313069