Article ID: 311236
Article Last Modified on 1/31/2007
APPLIES TO
- Microsoft Windows 98 Standard Edition
- Microsoft Windows 98 Second Edition
- Microsoft Windows Millennium Edition
This article was previously published under Q311236
SYMPTOMS
If you "hot dock" a device (such as a PC Card) while a Universal Serial Bus (USB) audio device is playing sound, one of the following symptoms may occur:
- Sound playback may cease for a short period.
- Sound playback may stop completely.
- Noise may be played back instead of the proper sounds.
- An error message may be displayed, or the audio program may stop responding (hang).
If the program hangs or automatically quits, Windows may become unstable. Microsoft recommends that you reboot the computer as soon as possible if you suspect that this has occurred, or if Windows seems to respond to input improperly.
CAUSE
This issue can occur if the Plug and Play configuration manager detects the insertion of the new device and initiates a resource rebalance. A Plug and Play resource rebalance stops the USB host controller, and then removes resources. The same, or new, resources are applied to the device before is it restarted. While it is stopped, the controller cannot communicate with any USB device. The audio device driver detects this condition and notifies the audio player. The response that you see depends on how the program handles the error.
RESOLUTION
To work around this problem, use any of the following methods:
- "Hot dock" PC Cards only when no sounds are being played back by a USB audio device (wait until playbacks stops, or stop it manually).
- Assign manual resources to the USB host controller. If your computer's basic input/output system (BIOS) provides USB legacy support, and it is enabled, please see the Microsoft Knowledge Base articles that are listed in the "References" section of this article for information about USB host controller settings.
Setting the USB Host Controller to Use Manual Settings
- Right-click My Computer, and then click Properties.
- Click the Device Manager tab.
- Expand the Universal serial bus controller item by double-clicking it.
- Click
Vendor namePCI to USB Host Controller, and then click Properties. - Click the Resources tab.
- To disable automatic settings, clear the Use automatic settings check box, if it is not already cleared.
- Click the Input/Output Range resource, and then click Change Setting.
- Select another value that does not result in a resource conflict.
- Restart your computer.
STATUS
Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
REFERENCES
For additional information about other USB devices, such as a USB printer, that are also affected by the problem that is described in this article, click the article number below to view the article in the Microsoft Knowledge Base:
263764 'Fatal Exception' Error Message or USB Devices May Not Work After You Insert PC Card
For additional information about manually configuring the USB host controller, click the article numbers below to view the articles in the Microsoft Knowledge Base:
310922 Computer Hangs During Shutdown with USB Legacy Support Enabled in the BIOS
310923 USB Keyboard or Mouse May Not Work After You Restart Your Computer in MS-DOS Mode
Additional query words: hwusb hwsndts hwpcmcia
Keywords: kbenv kbprb KB311236
