Article ID: 296814
Article Last Modified on 1/25/2006
APPLIES TO
- Microsoft Windows XP Home Edition
- Microsoft Windows XP Professional
This article was previously published under Q296814
SYMPTOMS
When you run Setup, Setup may appear to stop responding (hang), and you may receive the following message:
CAUSE
This issue may occur if any of the following conditions exist:
- You started Setup from DOS mode.
- You loaded the SMARTDrive tool and you used the following switches:
- /x
- /c
- /l
- InitCacheSize
- WinCacheSize
- /E:1024
- You did not load Smartdrv.exe prior to running Winnt.exe.
Note If you do not load Smartdrv.exe, or if you load Smartdrv.exe and you include command-line switches, the delay can be as long as 4 hours. If you load Smartdrv.exe with no switches, there is still a brief delay of approximately 45 seconds.
RESOLUTION
To resolve this issue, run the smartdrv command without any switches. You might have to modify the Autoexec.bat file to remark the entry for SMARTDRV, and then run SMARTDRV manually.
MORE INFORMATION
For more information about how to use switches with smartdrv, start a command prompt, access the drive where you loaded the SMARTDrive tool, and then type smartdrv /?.
Keywords: kbenv kbprb kbsetup KB296814
