Article ID: 264445
Article Last Modified on 1/27/2007
APPLIES TO
- Microsoft Visio 2000 Technical Edition
This article was previously published under Q264445
SYMPTOMS
In Visio 2000 Technical Edition, when you try to resize a wall shape, you may receive the following error message two times:
RESOLUTION
To resolve this problem, obtain Microsoft Visio 2000 Service Release 1 (SR-1).
To obtain SR-1, click the article number below to view the article in the Microsoft Knowledge Base:
263721 Visio: How to Obtain Microsoft Visio 2000 Service Release 1 (SR-1)
STATUS
Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article. This problem was corrected in Microsoft Visio 2000 SR-1.
MORE INFORMATION
Steps to Reproduce the Behavior
- Start Visio 2000 Technical Edition.
- Open any drawing.
- Place two wall shapes that intersect each other on the page.
- Try to resize the horizontal wall by aligning it with the vertical one.
Note that you receive the error message mentioned in the "Symptoms" section two times, and that the action is not carried out.
Additional query words: sr1
Keywords: kberrmsg KB264445
