Article ID: 240958
Article Last Modified on 2/22/2007
APPLIES TO
- Microsoft Host Integration Server 2000 Standard Edition
- Microsoft SNA Server 4.0
- Microsoft SNA Server 4.0 Service Pack 1
- Microsoft SNA Server 4.0 Service Pack 2
This article was previously published under Q240958
SYMPTOMS
When you try to use the SNA Server command line utility Snacfg.exe to edit the Host Account Cache from a computer in a remote Windows NT domain, the following error message may occur:
Example:
SNACFG #Drive:\path\com.cfg HSMAPPING ABC\USERXXX /ADD /HSDOMAIN:LMVSTS /HSUSER:XXXX
CAUSE
Snacfg.exe does not support the use of these commands from a Windows NT domain that is different than the Windows NT domain where the master Windows NT Account Synchronization (SNAPMP) service is running.
This behavior is by design.
RESOLUTION
The following criteria must be met in order to properly run Snacfg.exe:
- The user must be a member of the domain where the Windows NT Password Synchronization Service has been installed.
- Because Snacfg.exe requires some additional SNA Server Manager components to function properly, Snacfg.exe must be run from a computer that also has SNA Server or the SNA Server client for Windows NT with SNA Server Manager installed.
MORE INFORMATION
If the user logged in is not a member of the domain where the Windows NT Password Synchronization Service has been installed, a trust relationship must be established between the two domains.
For additional information on using Snacfg.exe to configure Host Security Domains, please see the following article in the Microsoft Knowledge Base:
236847 SNACFG Should Allow Configuration of Host Security Domains
Additional query words: Host Security
Additional query words: HIS 2000
Keywords: KB240958
