Article ID: 212543
Article Last Modified on 10/11/2006
APPLIES TO
- Microsoft Word 2000 Standard Edition
This article was previously published under Q212543
SYMPTOMS
When you use the AutoTextEntries property to create AutoText entries, you may receive the following Microsoft Visual Basic for Applications error message:
CAUSE
By design, this error message occurs when the text string is longer than 255 characters.
WORKAROUND
Microsoft provides programming examples for illustration only, without warranty either expressed or implied. This includes, but is not limited to, the implied warranties of merchantability or fitness for a particular purpose. This article assumes that you are familiar with the programming language that is being demonstrated and with the tools that are used to create and to debug procedures. Microsoft support engineers can help explain the functionality of a particular procedure, but they will not modify these examples to provide added functionality or construct procedures to meet your specific requirements.
For more information about how to use the sample code in this article, click the article number below to view the article in the Microsoft Knowledge Base:
212536 OFF2000: How to Run Sample Code from Knowledge Base Articles
To work around this problem, modify the macro to insert the text string into the document, select it, add the selection as an AutoText entry, and then remove the text string. The following sample Visual Basic for Applications macro demonstrates this procedure:
Sub AutoTextEntryExample() Dim sATName As String Dim sATEntry As String Dim sATNewEntry As AutoTextEntry ' Sample AutoText Entry Name. sATName = "ExampleAutoTextEntryName" ' Sample AutoText Entry Text of 500 characters. sATEntry = String(500, "A") If Documents.Count = 0 Then Documents.Add If Len(sATEntry) < 256 Then ' If the length of the text is less than 256 characters, ' add it as a new AutoText Entry. Selection.Range.Collapse Set sATNewEntry = NormalTemplate.AutoTextEntries.Add _ (Name:=sATName, Range:=Selection.Range) sATNewEntry.Value = sATEntry Else ' If the length of the text is greater than 255 characters, ' insert it into the active document and add it as a new ' AutoText Entry. With Selection.Range .Collapse .Text = sATEntry .Select NormalTemplate.AutoTextEntries.Add _ Name:=sATName, Range:=Selection.Range .Delete End With End If End Sub
REFERENCES
For additional information about getting help with Visual Basic for Applications, click the article numbers below to view the articles in the Microsoft Knowledge Base:
212623 WD2000: Macro Programming Resources
226118 OFF2000: Programming Resources for Visual Basic for Applications
Additional query words: vb vba vbe
Keywords: kbautotext kbdtacode kberrmsg kbmacroexample kbnofix kbprb KB212543