Article ID: 173573
Article Last Modified on 10/31/2006
APPLIES TO
- Microsoft Windows NT Workstation 4.0 Developer Edition
- Microsoft Windows NT Server 4.0 Standard Edition
This article was previously published under Q173573
SYMPTOMS
After you install Double Click or Java Post Service Pack 3 (SP3) hotfixes, the system blue screens with a stop error message in Win32k.sys:
The first parameter is consistently 0xc000001d, the remaining parameters have varied.
The STOP screen occurs before you can attempt to uninstall the hotfix.
CAUSE
Installing the Post SP3 hotfix Double Click or Java after the GetAdmin hotfix causes the Win32k.sys file to be incompatible with the kernel.
The Win32k.sys file furnished with the Double Click hotfix and the Java hotfix is not compatible with the kernel furnished with the GetAdmin hotfix. The Win32k.sys file furnished with the GetAdmin hotfix is dated 7/12/97. The versions of Win32k.sys supplied with the other hotfixes have earlier dates.
RESOLUTION
Replace the Win32k.sys file with the version from the GetAdmin hotfix, dated 7/12/97.
If the operating system is installed on a FAT partition, this can be accomplished by starting the system with a DOS boot floppy disk and copying the correct Win32k.sys from the most recently installed hotfix uninstall directory to the System32 directory.
The Double Click hotfix uninstall directory is $NTUninstallQ170510$. The Java hotfix uninstall directory is $NTUninstallQ168748$. Both reside under the system root directory, usually called \Winnt.
If the operating system is installed on an NTFS partition, a parallel installation of the operating system can be done and the file can be replaced in the manner described above while you are booted to the parallel installation.
If a parallel installation is not possible (for example, there is insufficient disk space), perform the following steps:
- Make a copy of the current Emergency Repair Disk (ERD).
- Delete the registry hives from the ERD you just copied (this is required in order to make sufficient space for the Win32k.sys file on the disk).
- Copy the correct version of the Win32k.sys file to the root of the ERD (the file can be obtained by running the hotfix with the /x option on a system running Windows NT 4.0. This extracts the files without installing the fix).
- Change the attributes of the Setup.log file on the ERD (use the attrib - s -h -r Setup.log command).
Add the following information to the BEGINNING of the section:
[Files.WinNt]: \Winnt\System32\Win32k.sys = "win32k.sys","12d370","\","nt40 repair disk","win32k.sys"- Run the Emergency Repair Procedure, verifying system files only.
- When prompted, replace the Win32k.sys file.
- After replacing the Win32k.sys file, exit setup. This leaves the other files intact.
- Restart the system.
For more information on replacing system files using a modified Emergency Repair Disk see the following Microsoft Knowledge Base article:
ARTICLE-ID: 164471
TITLE : Replacing System Files Using a Modified Emergency Repair Disk
Additional query words: 0X1E
Keywords: kbprb KB173573
