Microsoft KB Archive/171540

Knowledge Base

FIX: VFP Disappears if Project Under SCC Opened and Closed

Article ID: 171540

Article Last Modified on 8/17/1999

---

APPLIES TO

• Microsoft Visual Studio 97 Service Pack 3

---

This article was previously published under Q171540

SYMPTOMS

After applying Visual Studio 97 Service Pack 2 to a Windows NT system that has Visual FoxPro v5.0x and Visual SourceSafe v5.0x, if you open and then close a Visual FoxPro project that is under Source Code Control, then Visual FoxPro shuts down without any warnings or error messages.

STATUS

Microsoft has confirmed this to be a bug in the Microsoft products listed at the beginning of this article. This bug has been fixed in Visual Studio 97 Service Pack 3.

For more information, please see the following article in the Microsoft Knowledge Base:

170365 INFO: Visual Studio 97 Service Packs - What, Where, and Why

MORE INFORMATION

Steps to Reproduce Behavior

1. On a system that has Visual SourceSafe v5.0x and Visual FoxPro v5.0x, apply the Visual Studio 97 Service Pack 2. This should update Visual SourceSafe and Visual FoxPro files.
2. Run Visual FoxPro and open a project that is under Source Code Control.
   
   NOTE: If you do not already have a project under Source Code Control, then create a new project or use an existing project and add it to Source Code Control. For additional information, please see the following article in the Microsoft Knowledge Base:

   157636 HOWTO: Set Up Source Code Control with SourceSafe

3. Close the Project and leave Visual FoxPro running. After a wait of about 10 minutes, you'll note that Visual FoxPro is not visible on the Windows Task bar and has shut down without any warnings or error messages.
   
   NOTE: Similar problems exist under Windows 95. The difference is that Visual FoxPro generates an Exception Error and then it is shut down.

Keywords: kbbug kbfix kbvs97sp2fix KB171540

---

Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.