Article ID: 171267
Article Last Modified on 10/31/2006
APPLIES TO
- Microsoft Windows NT Workstation 3.51
This article was previously published under Q171267
SUMMARY
This article describes how to install Remote Access Service (RAS) in Windows NT Workstation version 3.51.
MORE INFORMATION
To install RAS, follow these steps:
- In Control Panel, double-click Network.
NOTE: If you have not set up networking on your computer, you are prompted to do so at this time. Click Yes to install networking, and then continue installing RAS.
- Click Add Software.
- In the Network Software box, click Remote Access Service, and then click Continue.
- Click the appropriate port, and then click Configure.
NOTE: If you have not installed a modem, you are prompted to do so at this time. Click Yes to install your modem, and then continue installing RAS.
- In the Attached Device box, click the appropriate modem.
- In the Port Usage box, click the appropriate option, and then click OK.
- Click Network, verify your network configuration, and then click OK.
- Click Continue, and then click OK until all dialog boxes are closed. Restart the computer when prompted.
To start the Remote Access Server Service, follow these steps:
- In the Remote Access group, double-click Remote Access Admin.
- On the Server menu, click Start Remote Access Service.
To connect using Remote Access Service, follow these steps:
- In the Remote Access group, double-click Remote Access.
- If you have not created a phone book entry, you are prompted to do so. If you have created a phone book entry, click New.
- Type the name and phone number.
- To configure the modem, X.25, ISDN, network, or security, click Advanced.
- Click OK to save the entry.
- In the Remote Access dialog box, click the appropriate entry, and then click Dial.
Keywords: kbenv kbhowto KB171267
