Article ID: 162515
Article Last Modified on 11/4/2003
APPLIES TO
- Microsoft SNA Server 3.0
- Microsoft SNA Server 2.11 Service Pack 1
This article was previously published under Q162515
SYMPTOMS
A hyphen and the letter B (-B) are printed at the end of a TN3270 print job.
CAUSE
The TN3270 Server is sending down a WCC byte to the emulator (with the unlock keyboard byte enabled). This would be appropriate for a display session in order to give the emulator direction to send more data back to the host. However, because this is a printer session, the emulator instead interprets this byte as data and prints it.
RESOLUTION
Apply the fix referenced below. A fix was made to the TN3270 Server to not send this byte sequence over printer sessions at the end of the print job.
STATUS
Microsoft has confirmed this to be a problem in SNA Server versions 2.11 and 2.11 Service Pack 1. A supported fix is now available for SNA Server 2.11 SP1, but has not been fully regression-tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the next Service Pack that contains this fix. Contact Microsoft Technical Support for more information.
Keywords: kbbug kbfix kbnetwork KB162515
