Microsoft KB Archive/157807

Knowledge Base

Enabling AutoDial with Internet Explorer in Windows NT 4.0

Article ID: 157807

Article Last Modified on 11/1/2006

---

APPLIES TO

• Microsoft Windows NT Server 4.0 Standard Edition
• Microsoft Windows NT Workstation 4.0 Developer Edition

---

This article was previously published under Q157807

SUMMARY

You can use the AutoDial feature in Windows NT 4.0 to automatically prompt you to dial a phonebook entry when you try to connect to a network or Internet path that is not available or cannot be found. For example, when you double-click the Internet Explorer icon, Microsoft Internet Explorer attempts to load your start page. If you are not connected to your Internet service provider (ISP), you receive the following error message:

Microsoft Internet Explorer
Internet Explorer cannot open the Internet site http://<web address>.
The site was not found. Make sure the address is correct, and try again.

With AutoDial correctly configured, you are prompted to dial your ISP.

MORE INFORMATION

To configure AutoDial, follow all of the steps in each of the following sections.

Enable AutoDial By Location

1. Double-click My Computer and then double-click Dial-Up Networking.
2. In the Phonebook Entry To Dial box, click the entry for your ISP.
3. Click More, click User Preferences, and then verify that the location from which you are dialing is selected. Click OK.

Remote Access Services Must Be Started

1. In Control Panel, double-click Services.
2. Locate the following two services and verify that they are started:
   • Remote Access AutoDial Manager
   • Remote Access Connection Manager

Manually Set Your Start Page

1. Using Dial-Up Networking, connect to your ISP.
2. Start Internet Explorer, and then connect to the Web page that you want to use as your start page.
3. On the View menu, click Options.
4. Click the Navigation tab.
5. In the Page box, click Start Page, and then click Use Current.
6. Click OK.

The next time you start Internet Explorer without being connected to your ISP, you will be prompted to dial the connection.

For additional information about AutoDial, please see the following article in the Microsoft Knowledge Base:

ARTICLE-ID: 152220
TITLE : How to View and Remove Information from AutoDial

Additional query words: 4.0 ras dialup dun

Keywords: kbfaq kbhowto kbnetwork KB157807

---

Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.