Microsoft KB Archive/150358

Microsoft Knowledge Base

PRB: Can't Run Eddie Stand-Alone (eddiebatch) on a Remote Host

Last reviewed: April 29, 1996
Article ID: Q150358

The information in this article applies to:

• Softimage Eddie for IRIX, version 3.2a

SYMPTOMS

It is impossible to run the Softimage Eddie stand-alone (eddiebatch) on a remote host even though the following steps have been completed:

1. You used rlogin to log onto the remote host and entered this command:

   which eddiebatch

2. You supplied the correct path to the executable file. However, when the command "rsh hostname which eddiebatch" is entered, a correct path cannot be found.

CAUSE

By design, the .eddie file, which sets the path to eddiebatch, is being sourced by the remote account's .login file rather than by its .cshrc file.

STATUS

This behavior is by design.

NOTE: Softimage Inc. is a wholly owned subsidiary of Microsoft Corporation.

Additional reference words: 3.20a KBCategory: kbgraphic kbprb KBSubcategory: si ed edst-al THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Last reviewed: April 29, 1996 ©1997 Microsoft Corporation. All rights reserved. Legal Notices.