Article ID: 148971
Article Last Modified on 11/26/2003
APPLIES TO
- Microsoft SNA Server 2.0, when used with:
- Microsoft Windows NT 4.0
- Microsoft SNA Server 2.1, when used with:
- Microsoft Windows NT 4.0
- Microsoft SNA Server 3.0, when used with:
- Microsoft Windows NT 4.0
- Microsoft SNA Server 2.11 Service Pack 1, when used with:
- Microsoft Windows NT 4.0
This article was previously published under Q148971
SYMPTOMS
When you run the SNA Server client software configured to use the Novell NetWare IPX/SPX client interface on Token Ring, the client is unable to find a SNA Server located across an FDDI transitional bridge.
When the problem occurs on a SNA Server Microsoft Windows 3.x client, Wnap.exe will display the following error when it is started:
Microsoft Windows NT and Microsoft Windows 95 clients will indicate that the SnaBase service is not started.
CAUSE
When you connect a SNA Server IPX/SPX client from a Token Ring network to a SNA Server located on FDDI, the intervening FDDI bridge may bit-swap the destination address of the IPX/SPX connection request, causing the SNA client to fail to connect to the SNA Server.
This problem only occurs when SNA Server clients are configured to use NetWare IPX/SPX on Token Ring, where the server's IPX address is based on the network card adapter address installed in the SNA Server.
Ethernet-attached IPX clients will not encounter this problem because the FDDI bridge does not bit-flip destination addresses when bridging frames. Also, all other client-server connection methods supported by SNA Server (for example, named pipes, TCP/IP sockets, Banyan IP, and AppleTalk) do not directly refer to the server's adapter address when it connects to the server and will not encounter this problem.
RESOLUTION
To support this configuration, an update to the SNA Server client software is available that supports "bit flipping" of the SNA Server's IPX address. It will try if the following new SNA Server client setting is enabled:
FlipMacAddress=Yes
For Windows 3.x clients, this setting must be added to the [WNAP] section of the Win.ini file.
For Windows NT clients, this setting must be as follows:
HKEY_LOCAL_MACHINE/SYSTEM/CurrentControlSet/Services/SnaBase/
Parameters/SnaSpx/
FlipMacAddress: REG_SZ: Yes
For Windows 95 clients, this setting must be as follows:
HKEY_LOCAL_MACHINE/Software/Microsoft/SnaBase/Parameters/SnaSpx/
FlipMacAddress: REG_SZ: Yes
If this value is set to Yes, the SNA Server client NetWare transport first tries the bit flipped server address, and if it fails, it retries with the original non-flipped address.
For additional information on the algorithm for bit-flipping network addresses, please see the following article in the Microsoft Knowledge Base:
123791 SNA Server Remote Station Discovery Process
STATUS
Microsoft has confirmed this to be a problem in SNA Server 2.0, 2.1, 2.11, and 2.11.sp1.
This problem was corrected in the latest Microsoft SNA Server 2.11 U.S. Service Pack. For information on obtaining the service pack, query on the following word in the Microsoft Knowledge Base (without the spaces):
S E R V P A C K
Keywords: kbbug kbfix kbnetwork KB148971
