Article ID: 126308
Article Last Modified on 11/1/2006
APPLIES TO
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Workstation 3.51
- Microsoft Windows NT Workstation 4.0 Developer Edition
- Microsoft Windows NT Server 3.5
- Microsoft Windows NT Server 3.51
- Microsoft Windows NT Server 4.0 Standard Edition
This article was previously published under Q126308
SUMMARY
You may encounter problems when you attempt to establish a connection to a remote NetWare Server from a Windows NT Remote Access Service (RAS) client that is dialing into a Windows NT RAS Server. This problem will occur if the NetWare Server and the Windows NT RAS Server are on different network segments.
To correct this problem, assign a unique IPX network number to the segment that the Windows NT RAS Server is located on. Alternatively, install the NetWare Server on the same network segment as the Windows NT RAS Server.
MORE INFORMATION
Windows NT 3.5x
To assign a unique IPX network number to the network segment that the Windows NT RAS Server is located on, perform the following steps:
- Determine a unique IPX network number. That is one that does not conflict with any previously assigned IPX network numbers.
- On the Windows NT RAS Server, choose Network in Control Panel.
- In the list of Installed Network Software, select NWLink IPX/SPX Compatible Transport.
- Choose the Configure button.
- In the Adapter box, select the network card driver.
- Enter the unique IPX network number from Step 1 above into the Internal Network Number box.
- Choose the OK button in both the NWLink IPX/SPX Protocol Configuration dialog box and the Network Settings dialog box.
- Shutdown and restart Windows NT.
Windows NT 4.0
In Windows NT version 4.0, you can change both the (external) network number and internal network number through the Graphic User Interface (GUI) in Control Panel. Use the following steps:
To set or change the external network number:
- Click Start, point to Settings, and click Control Panel.
- Double-click Network, click Protocols, and double-click NWLink IPX/SPX Compatible Transport.
- Select the appropriate adapter in the Adapter list and click the Manual Frame Type Detection radio button.
- Click Add, select the correct frame type and type your unique (external) network number.
For additional information, please see the following article in the Microsoft Knowledge base:
150546: NWLink IPX/SPX: Network Number .vs. Internal Network Number
NetWare is manufactured by Novell Inc., a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Additional query words: prodnt
Keywords: kbnetwork KB126308
