Article ID: 124299
Article Last Modified on 11/1/2006
APPLIES TO
- Microsoft Windows NT Server 3.5
- Microsoft Windows NT Server 3.51
- Microsoft Windows NT Server 4.0 Standard Edition
This article was previously published under Q124299
SYMPTOMS
When you install Services for Macintosh (SFM) under Windows NT Server version 3.5, and you are using a Xircom CE10 PCMCIA Ethernet adapter, the following error message appears:
WORKAROUND
Although SFM is not displayed in the Network Settings Installed Network Software list, entries for AppleTalk protocol are added to the Windows NT bindery. As a result, you must modify the registry to enable SFM.
WARNING: Using Registry Editor incorrectly can cause serious, system-wide problems that may require you to reinstall Windows NT to correct them. Microsoft cannot guarantee that any problems resulting from the use of Registry Editor can be solved. Use this tool at your own risk.
- Run Registry Editor (REGEDT32.EXE).
- From the HKEY_LOCAL_MACHINE subtree, go to the following key:
SYSTEM\CurrentControlSet\Services\AppleTalk\Parameters
- Highlight DefaultPort.
- From the Edit menu, choose String.
- Add the following value:
\Device\CE2NDIS31
- Highlight DesiredZone.
- From the Edit menu, choose String.
- Add the correct AppleTalk zone.
- Close Registry Editor, and then shut-down and restart Windows NT.
Macintosh clients should now be able to connect to the Windows NT Server.
NOTE: Every time you attempt to configure SFM from Control Panel, the following error message appears:
Consequently, changes to SFM must be made through Registry Editor (REGEDT32.EXE).
STATUS
Microsoft has confirmed this to be a problem in Windows NT Server versions 3.5, 3.51, and 4.0. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
Additional query words: prodnt mac
Keywords: kbnetwork KB124299
