Microsoft KB Archive/122938

Knowledge Base

Telnet is Not a Valid Option in Windows NT 3.5 Terminal

Article ID: 122938

Article Last Modified on 11/1/2006

---

APPLIES TO

• Microsoft Windows NT Workstation 3.5
• Microsoft Windows NT Workstation 3.51
• Microsoft Windows NT Server 3.5
• Microsoft Windows NT Server 3.51

---

This article was previously published under Q122938

SYMPTOMS

Under Windows NT version 3.5x, if you attempt to set up Telnet in Terminal (rather than using the new Telnet utility), the following error message appears after you select Telnet:

Terminal failed to open the Telnet session. Please use the Services option in the Control Panel to make sure that the Telnet service is started.

The only option you can select is OK.

Under Windows NT version 3.1, this was a valid selection.

CAUSE

Under Windows NT version 3.5x, you need to run TELNET.EXE.

NOTE: By default, Telnet is not installed until you select to install TCP/IP connectivity utilities.

STATUS

Microsoft has confirmed this to be a problem in Windows NT versions 3.5 and 3.51. We are researching this problem and will post new information here as it becomes available.

Additional query words: prodnt

Keywords: kbnetwork KB122938

---

Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.