Article ID: 120707
Article Last Modified on 7/1/2004
APPLIES TO
- The Integrated Debugger, when used with:
- Microsoft Visual C++ 2.0 Professional Edition
- Microsoft Visual C++ 2.1
- Microsoft Visual C++ 4.0 Standard Edition
- Microsoft Visual C++ 4.1 Subscription
- Microsoft Visual C++ 5.0 Standard Edition
- Microsoft Visual C++ 6.0 Service Pack 5
This article was previously published under Q120707
SUMMARY
You can debug an active process with 32-bit editions of Microsoft Visual C++. You can attach to the active process by starting Visual C++ using the undocumented -p switch, followed by the process identification number (PID).
MORE INFORMATION
To obtain the PID for the process to be debugged, use the process viewer (PVIEW.EXE). Start PView. You will see something like this:
Process CPU Time Privileged User
MyApp(0xb7) ...
Here 0xb7 is the PID value of the application named MyApp.
Assume that the process was built with debugging information. Start Visual C++ version 2.x as follows:
MSVC -p 0xb7
Or, start Visual C++ version 4.0 or later as follows:
MSDEV -p 0xb7
NOTE: Beginning with Visual C++ 5.0, you can also attach to a process by selecting the following menu option:
Build::Start Debug::Attach to Process...
When Visual C++ is loaded, look for statements in the status bar at the bottom of the screen stating that symbols for the application and its DLLs have been loaded. At this point, select the Debug menu, and choose the Break option to see the assembler listing in the main window. Bring up the call stack. Then double-click one of your functions. This brings up the source code for that source module in which a breakpoint can be set, or you can just open a source file and set a break point.
NOTE: When you stop debugging the application, the application will be terminated. This is expected behavior.
The procedure on Windows 95 is a little different with Visual C++ 2.0 through 4.0 (Visual C++ 4.1 and later handle the Windows 95 PID without conversion). The Windows 95 PIDs are negative signed decimals when converted from hexadecimal. You need to make sure the PID has a minus sign in front of it. For instance, if the PID of the process you want to attach to is FFFE64C3, you can use this method with calculator to get the PID:
Hex PID -> [Not] -> (DEC) -> [Not] -> Dec PID
The double negation is to trick calculator into giving you the correct number. Otherwise, it gives you the unsigned decimal equivalent of the hex number, which is well outside the valid PID range. In this example, you should get a Dec PID of -105277. The command line to attach, then, is simply:
start msdev -p -105277 -e -105277
If you pass an invalid PID, you might receive an error like:
Additional query words: current running attach
Keywords: kbhowto kbbug kbide kbdebug KB120707
