Article ID: 120219
Article Last Modified on 10/31/2006
APPLIES TO
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Server 3.5
This article was previously published under Q120219
3.50
WINDOWS
kbsetup kbbug3.50
SYMPTOMS
Your Gateway2000 computer with a Mitsumi CD-ROM drive hangs on the first re- boot during a Windows NT 3.5 install or upgrade.
CAUSE
Windows NT automatic hardware detection fails during the first re-boot of installation with the Mitsumi drive. On subsequent re-boots, NT does not repeat the hardware detection because it has already recorded information about the machine in the registry.
WORKAROUND
Remove the CD-ROM interface card (a very small card with a cable leading to the CD-ROM). Re-boot and complete the installation. Once you have NT installed to the point where you can log on, turn off your computer and reinsert the card.
STATUS
Microsoft has confirmed this to be a problem in Windows NT version 3.5. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
Additional query words: prodnt
Keywords: KB120219
