Article ID: 111910
Article Last Modified on 10/10/2003
APPLIES TO
- Microsoft MS-DOS 6.0 Standard Edition
- Microsoft MS-DOS 6.2 Standard Edition
This article was previously published under Q111910
SYMPTOMS
When you run the Stacker Conversion utility for MS-DOS 6.0 or 6.2, you may receive the following error message:
CAUSE
This message occurs when the Stacker Conversion utility detects DBLSPACE.BIN in memory at the same time as STACKER.COM. The two drivers should not be in memory at the same time. This problem can occur if STACKER.COM is loading in the CONFIG.SYS file and the DBLSPACE.INI file is located in the root directory of the boot drive, causing DBLSPACE.BIN to remain in memory at startup.
RESOLUTION
You can prevent DBLSPACE.BIN from loading in memory by renaming the file DBLSPACE.INI. The steps below outline this procedure.
- Change to the root directory of the boot (uncompressed) drive and locate the file DBLSPACE.INI.
- Remove the file attributes from the DBLSPACE.INI file by typing attrib dblspace.ini -s -h -r.
- Rename the file by typing ren dblspace.ini dblspace.inx.
- Restart the computer (with the Stacker driver(s) loading in the CONFIG.SYS file), and run the Stacker Conversion utility again.
MORE INFORMATION
The product Stacker is manufactured by STAC Electronics, a vendor independent of Microsoft. We make no guarantee, implied or otherwise, regarding this product's performance or reliability.
Additional query words: 6.20
Keywords: KB111910