Microsoft KB Archive/105260

Knowledge Base

Err Msg After Uncompressing: You Cannot Access Any...

Article ID: 105260

Article Last Modified on 11/22/1999

---

APPLIES TO

• Microsoft MS-DOS 6.2 Standard Edition
• Microsoft MS-DOS 6.22 Standard Edition

---

This article was previously published under Q105260

SUMMARY

This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames.

SYMPTOMS

After removing MS-DOS DoubleSpace, you may receive the following error message:

You cannot access any DoubleSpace drives because the DoubleSpace driver, DBLSPACE.BIN, is not installed.

CAUSE

This error is generated if DoubleSpace fails to remove any DEVICE=C:\DOS\DBLSPACE.SYS commands from your CONFIG.SYS file. This situation typically occurs if you have followed the sequence below.

1. Installed MS-DOS 6.0.
2. Installed DoubleSpace.
3. Installed MS-DOS 6.2.
4. Uncompressed your DoubleSpace drives.
5. Removed MS-DOS 6.2.

RESOLUTION

To work around this situation, edit your CONFIG.SYS file and remove all DEVICE=C:\DOS\DBLSPACE.SYS commands.

Additional query words: 6.20 uninstalling

Keywords: KB105260

---

Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.