Microsoft KB Archive/102792

From BetaArchive Wiki
< Microsoft KB Archive
Revision as of 15:02, 18 July 2020 by 3155ffGd (talk | contribs) (importing KB archive)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Knowledge Base


Article ID: 102792

Article Last Modified on 2/20/2007



APPLIES TO

  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • Microsoft Windows 2000 Professional Edition
  • Microsoft Windows NT Advanced Server 3.1
  • Microsoft Windows NT Workstation 3.1
  • Microsoft Windows NT Advanced Server 3.1
  • Microsoft Windows NT Server 4.0 Standard Edition
  • Microsoft Windows NT Workstation 4.0 Developer Edition



This article was previously published under Q102792


SYMPTOMS

If you are connected directly to a Hewlett-Packard (HP) network printer using Data Link Control (DLC), you may not be able to print if another workstation is connected to the same printer and it is configured to use Continuous Timers.

CAUSE

If a workstation is connected to an HP network printer and is using Continuous as the Timer, it will not relinquish the printer after printing and other workstations cannot print even though they are connected.

RESOLUTION

To work around this problem, follow the procedure below for each workstation connected to the HP network printer:

  1. Start Print Manager and select the network printer.
  2. Select Printer Properties. In the Hewlett-Packard Network Peripheral Port dialog box, select Timers.
  3. Change the setting to Job Based instead of Continuous. The default is Continuous with 60 sec Time Interval.


MORE INFORMATION

The Job Based option breaks the connection between available workstations and the printer after each job. This allows several workstations on the network to use the HPMON.DLL printer driver to print directly to a network-connected peripheral.

The Continuous option does not break the connection between the server and the printer. It is possible to set up a Print Server so that workstations that want to print to the DLC printer must use the shared printer defined on the server. This allows the network administrator to maintain one workstation as a print server so that other workstations do not have to have the HPMON.DLL printer driver installed.

NOTE: On a single LAN, only one of these methods should be used. If one workstation is configured for Job Based (as is the HP Monitor utility for Windows for Workgroups), while another workstation is configured for Continuous, the workstation using the Job Based configuration will be unable to print after the workstation using Continuous has printed.


Additional query words: wfw wfwg prodnt

Keywords: kbprint kbnetwork KB102792