Article ID: 99415
Article Last Modified on 5/12/2003
APPLIES TO
- Microsoft MS-DOS 2.11 Standard Edition
- Microsoft MS-DOS 3.1
- Microsoft MS-DOS 3.2 Standard Edition
- Microsoft MS-DOS 3.21 Standard Edition
- Microsoft MS-DOS 3.3 Standard Edition
- Microsoft MS-DOS 3.3a
- Microsoft MS-DOS 4.0 Standard Edition
- Microsoft MS-DOS 4.01 Standard Edition
- Microsoft MS-DOS 5.0 Standard Edition
- Microsoft MS-DOS 5.0a
- Microsoft MS-DOS 6.0 Standard Edition
- Microsoft MS-DOS 6.2 Standard Edition
- Microsoft MS-DOS 6.21 Standard Edition
- Microsoft MS-DOS 6.22 Standard Edition
This article was previously published under Q99415
SUMMARY
This article lists the error messages you may receive if you have a hardware failure on the hard disk, the hard disk controller, or both. The errors listed below normally occur during a low-level format but may also occur anytime after the low-level format is done (for example, when you are installing MS-DOS, Windows, or other software).
MORE INFORMATION
Code Description
------------------------------------------------
00H No Error
01H Bad Command
02H Address Mark Not Found
03H Write Protect
04H Request Sector Not Found
05H Reset Failed
06H Media Change
07H Initialization Failed
09H Cross 64K DMA Boundary
0AH Bad Sector Flag Detected
0BH Bad Track Flag Detected
10H Bad ECC on Disk Read
11H ECC Corrected Data Error
20H Controller Has Failed
40H Seek Operation Failed
80H Drive Failed to Respond
AAH Drive Not Ready
BBH Undefined Error
CCH Write Fault
0EH Register Error
FFH Sense Operation Failed
Additional query words: 6.22 2.0 3.0 3.00 3.10 3.1 3.3 3.30 3.3a 3.30a 4.0 4.00 4.01 4.01a 5.00 5.0 5.00a 5.0a 6 6.00 6.0 6.20 msdos ms dos hard drive errors failures lowlevel low level format
Keywords: KB99415
