Article ID: 70144
Article Last Modified on 10/23/2003
APPLIES TO
- Microsoft Programmer's Workbench for MS-DOS 1.0
- Microsoft Programmer's Workbench for OS/2 1.0
This article was previously published under Q70144
SUMMARY
The descriptions for some PWB errors do not appear in the online help files that shipped with C version 6.0. These errors are U1350, U1351, U1352, U1353, U1354, and U1355. The online help for C version 6.0a does contain the information on these errors.
MORE INFORMATION
The following is a list of PWB errors and accompanying explanations that are not in the C 6.0 online help:
PWB.COM Error U1350
PWB.COM could not find or load PWBED.EXE.
Make sure PWBED.EXE can be found on the PATH environment variable,
and that there is sufficient memory to operate PWB.
Check that your environment contains the recommended settings from
the NEW-VARS.BAT file created by the Setup program when you
installed PWB.
PWBED.EXE is the executable file for the PWB editor and
environment. PWB.COM processes the command line at start-up, and
handles all system-level commands when building projects and
executing Shell, User, Print, and Compile commands.
PWB.COM Error U1351
There is not enough available memory to complete the operation.
You may have too many TSR programs installed. Remove some TSRs.
A previous command may not have released memory when it terminated.
This can happen if you attempt to run a TSR from within PWB.
You may have too many active command shells. Leave the current
shell with the operating-system Exit command.
PWB.COM Error U1352
The COMPSEC environment variable is not defined.
PWB requires COMSPEC to be set to the full path name of the
operating system command processor.
PWB.COM Error U1353
PWB.COM encountered an error while reading the file that contains a
script of commands to execute during a shell or build operation.
This can be caused by a CTRL+BREAK or a disk error while reading
the script file.
PWB.COM Error U1354
PWB.COM was unable to execute the given command.
Some possible causes for this error are:
- The executable file for the command was not found.
- The path name of the command was not found.
- The operating system denied access to the file; it is in use by another program.
- There is not enough available memory to execute the command.
- A previous command may not have released memory when it terminated. This can happen if you attempt to run a TSR from within PWB.
- The environment is corrupt.
- The executable file is corrupt.
PWB.COM Error U1355
An operating system command or executable program could not be
executed.
The command may be spelled incorrectly, or it does not exist on the
paths specified in the PATH environment variable. Make sure that
your environment contains the recommended settings from the
NEW-VARS.BAT file created by the Setup program when you installed
PWB.
Additional query words: 1.00 docerr
Keywords: kb16bitonly KB70144
