Article ID: 329603
Article Last Modified on 2/28/2007
APPLIES TO
- Microsoft Exchange 2000 Server Standard Edition
This article was previously published under Q329603
SYMPTOMS
Your Recipient Update service server may not stamp SMTP addresses on new stores and mailboxes.
CAUSE
This problem may occur if the following conditions exist:
- You move your Recipient Update service server to new hardware.
- You run the setup /disasterrecovery command to establish the Recipient Update service configuration on the new hardware.
WORKAROUND
To work around this problem, manually set up the Recipient Update service to run on the new server, and then rebuild the Recipient Update service.
STATUS
Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
MORE INFORMATION
For additional information about how to work with the Recipient Update service, click the article number below to view the article in the Microsoft Knowledge Base:
319065 HOW TO: Work with the Recipient Update Service in Exchange 2000
Additional query words: rus
Keywords: kbbug kbenv kbpending KB329603
