Article ID: 327768
Article Last Modified on 2/1/2007
APPLIES TO
- Microsoft Office 2000 Premium Edition
- Microsoft Office 2000 Professional Edition
- Microsoft Office 2000 Standard Edition
- Microsoft Office 2000 Small Business Edition
- Microsoft Office 2000 Developer Edition
- Microsoft Access 2000 Standard Edition
- Microsoft Excel 2000 Standard Edition
- Microsoft FrontPage 2000 Standard Edition
- Microsoft Outlook 2000 Standard Edition
- Microsoft PowerPoint 2000 Standard Edition
- Microsoft Word 2000 Standard Edition
This article was previously published under Q327768
SYMPTOMS
When you try to install Microsoft Office 2000, you may receive the following error message:
CAUSE
This behavior may occur if one of the following conditions is true:
- The installation CD-ROM is dirty or unreadable.
-or-
- Files that the installation program has to have became corrupted or were deleted when an earlier version of Office was removed.
RESOLUTION
To resolve this behavior, use method 1 to clean the CD-ROM. If that does not succeed, use method 2.
Method 1: Clean the CD-ROM
When you clean a CD-ROM, it is important not to damage the surface. Clean your CD-ROM with a commercially available CD-ROM cleaner and scratch remover, or use a clean, soft, cotton cloth. To clean the CD-ROM with a clean, soft, cotton cloth, follow these steps:
- Hold the CD-ROM by placing your index finger in the center hole and your thumb on the outside edge.
- Hold the CD-ROM with the read surface (the shiny side) up, and then breathe onto the CD-ROM so that your breath fogs the surface.
- Wipe the fogged area of the disc with the soft cloth, in a straight line, from the center of the disc to the outside edge.
- Repeat steps 1 through 3 until the whole surface is clean.
- When the CD-ROM is clean, put it into your CD-ROM drive, and then try to install Office 2000. If you receive the error message, go to the next method.
Method 2: Run Setup with the DONOTMIGRATEUSERSETTINGS=True Command
If an earlier version of Office has been removed, some files that the Office 2000 installer has to have may have been removed or corrupted. As a result, the Setup program cannot migrate settings from the earlier version of Office. To install Office 2000 without migrating settings from an earlier version of Office, follow these steps:
- Put the Office 2000 installation CD-ROM into the CD-ROM drive.
- Click Start, point to All Programs, point to Accessories, and then click Command Prompt.
- At the command prompt, type
where
D:\SETUP.EXE DONOTMIGRATEUSERSETTINGS=TrueDis the drive letter of your CD-ROM drive, and then press ENTER.
MORE INFORMATION
For additional information about Internal Error 2735, click the article numbers below to view the articles in the Microsoft Knowledge Base:
305504 OFF2000: Internal Error 2735 Referencing Out128.dll When You Install Office 2000
237957 OFF2000: How to Use an Office 2000 Setup Log File to Troubleshoot Setup Problems
304501 OFFXP: Error Message When You Upgrade from Office 2000 SR-1: Error 2735 OPC Remove
Additional query words: OFF2000
Keywords: kberrmsg kbprb KB327768
