Article ID: 264411
Article Last Modified on 1/27/2007
APPLIES TO
- Microsoft Visio 2000 Technical Edition
This article was previously published under Q264411
SYMPTOMS
In Visio 2000 Technical Edition, when you try to rotate a door shape, the door may not rotate as expected.
CAUSE
The rotate feature was changed in Visio 2000 Technical Edition to "flip" the doors rather than to rotate the doors. The rotate feature has been re-implemented in Visio 2000 SR-1.
RESOLUTION
To add the re-implemented feature to Visio 2000 Technical Edition, obtain Microsoft Visio Service Release 1.
To obtain SR-1, click the article number below to view the article in the Microsoft Knowledge Base:
263721 Visio: How to Obtain Microsoft Visio 2000 Service Release 1 (SR-1)
To rotate doors in Visio 2000 Technical Edition:
- Right-click the door that you want to rotate, and then click the way that you want to "flip" the door. You can change the door to open in, instead of out, or right, instead of left
STATUS
Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article. This problem was corrected in Microsoft Visio 2000 SR-1.
MORE INFORMATION
Steps to Reproduce the Behavior
- Start Visio.
- Open the Office Layout Stencil.
- Drag a door onto the page.
- On the Standard toolbar, click Rotation Tool.
- Try to rotate the door by dragging the green circle.
Note that the door does not move.
Additional query words: sr1
Keywords: KB264411
