Article ID: 214073
Article Last Modified on 1/24/2007
APPLIES TO
- Microsoft Office Excel 2007
- Microsoft Office Excel 2003
- Microsoft Excel 2002 Standard Edition
- Microsoft Excel 2000 Standard Edition
- Microsoft Excel 97 Standard Edition
This article was previously published under Q214073
SYMPTOMS
When you save a document in Microsoft Excel, one of the following error messages may appear.
Message 1
Message 2
Message 3
Message 4
Message 5
Message 6
CAUSE
This problem will occur when the process that Excel uses to save a file is interrupted. For example, if you are saving to an external drive such as a network drive, the connection has been dropped. Or, if you are saving to a removable disk, such as a floppy diskette, the disk has been removed.
RESOLUTION
To continue working with this file, save the workbook to a different disk drive. You must restore the connection or correct the problem with the original target drive before you can save to that drive again.
MORE INFORMATION
When you work in a file, Microsoft Excel saves the file with a temporary file name and places this file in the same folder as the original file. When you save your file, the original file is then deleted and the temporary file is renamed with the original file name.
If this process is interrupted, your file may not be saved properly or you may find one or more temporary files in the folder where you tried to save your file. In addition, you may receive one of several alert or error messages.
The following information lists some of the possible messages you may receive and explanations as to why you may receive them.
"Cannot access read-only document <file name>"
The drive you are saving to is a network drive and you do not have sufficient privileges to save to that drive. Save to your local hard disk drive or to a floppy disk drive.
"Disk is full"
The drive you are saving to does not have enough space for the temporary file. Delete some files from the current drive and save to another drive or to a floppy disk drive.
"Document not saved," or "Document not completely saved"
The process was interrupted while creating the temporary file because you pressed ESC, there was some hardware or software failure, or there was another media problem. The original file is still intact and ,unless your computer or workstation failed, the version of the file containing your current changes is still open in memory. Save the file to an alternate drive. If your computer or workstation did fail, you can use the original file. (Note that any changes made in the last revision will be lost.)
"Document not saved. Any previously saved copy has been deleted"
The process was interrupted while deleting the original or renaming the temporary file. This problem will occur for the same reasons as the scenario described in the "'Document not saved,' or 'Document not completely saved'" section. In this case, your original file is gone (though the temporary file may be readable). If your computer or workstation failed, use the temporary file. If the interruption was caused by something else, the version of the file containing your current changes is still open in memory. Save the file to an alternate drive.
REFERENCES
For more information, click the following article numbers to view the articles in the Microsoft Knowledge Base:
223816 Error message: The disk is full
223812 Error message: Document not saved
Additional query words: XL2007 XL2000 temp XL2002 XL2003 XL97
Keywords: kbsavefile kberrmsg kbprb KB214073
