Registrations are now open. Join us today!
There is still a lot of work to do on the wiki yet! More information about editing can be found here.
Already have an account?

Microsoft KB Archive/38641

From BetaArchive Wiki
Knowledge Base


Changing Macintosh System Can Make QuickBASIC Fail to Run

Article ID: 38641

Article Last Modified on 1/9/2003



APPLIES TO

  • Microsoft QuickBasic Compiler for Macintosh 1.0



This article was previously published under Q38641

SUMMARY

The QuickBASIC Settings file stored in the System Folder will not allow QuickBASIC to load if there has been a system modification or change since the last time it was open.

If you have used QuickBASIC Version 1.00 for the Apple Macintosh on any given version of the system, then you have installed a new version of the system (such as System Version 6.0.2). QuickBASIC will begin loading, but it only will momentarily run before returning to the desktop.

To correct the problem, delete the QuickBASIC Settings file from the system folder; this forces QuickBASIC to build a new one.

MORE INFORMATION

Microsoft QuickBASIC Version 1.00 for the Apple Macintosh has the following system requirements:

  1. A Macintosh with a 128K ROM (such as the Macintosh Plus, Macintosh SE, or Macintosh II).
  2. System Version 4.10 or later.
  3. Finder Version 5.50 or later.
  4. Two disk drives, at least one of which must handle 800K disks.



Additional query words: MQuickB

Keywords: KB38641