Registrations are now open. Join us today!
There is still a lot of work to do on the wiki yet! More information about editing can be found here.
Already have an account?

Microsoft KB Archive/169158

From BetaArchive Wiki
Knowledge Base


Adding Interface to OSPF Does Not Enable the OSPF Protocol

Article ID: 169158

Article Last Modified on 11/1/2006



APPLIES TO

  • Microsoft Windows NT Server 4.0 Standard Edition
  • Microsoft Routing and Remote Access Service Update for Windows NT Server 4.0



This article was previously published under Q169158

SUMMARY

When you add an interface to OSPF by Bay Networks in Routing and Remote Access Service, the interface is not automatically OSPF enabled.

MORE INFORMATION

After you install OSPF by Bay Networks on a Routing and Remote Access Service router, you must specify which network interface cards will be enabled for OSPF. Perform the following steps to add a network card to the computer to use through OSPF:

  1. Right-click OSPF, and then click Add Interface.
  2. Select the network adapter card you want, and then click OK. At this point, you must select Enable OSPF on this interface. Just clicking OK will not enable OSPF on the interface.



Additional query words: rras prodnt 4.00 steelhead

Keywords: kbnetwork KB169158