Registrations are now open. Join us today!
There is still a lot of work to do on the wiki yet! More information about editing can be found here.
Already have an account?

Microsoft KB Archive/104725

From BetaArchive Wiki
Knowledge Base


How to Configure ScanDisk to Monitor Read/Write/Seek Times

Article ID: 104725

Article Last Modified on 11/18/1999



APPLIES TO

  • Microsoft MS-DOS 6.2 Standard Edition
  • Microsoft MS-DOS 6.22 Standard Edition



This article was previously published under Q104725

SUMMARY

ScanDisk has the capability to monitor the average read, write, and seek times during surface analysis. If ScanDisk determines a test of a particular area is taking too long, ScanDisk warns you that the area is nearing failure and offers to correct the data in the affected clusters.

This functionality is inactive by default but can be enabled by using a command line switch or by changing a setting in the SCANDISK.INI file.

MORE INFORMATION

To activate this functionality when you run ScanDisk, use the /TIME switch. For example, type scandisk c: /time at the MS-DOS command prompt and then press ENTER.

To configure ScanDisk to use this functionality every time you run it, use MS-DOS Editor to edit the Environment section of the SCANDISK.INI file and change ScanTimeOut=off to ScanTimeOut=on.

For more information on how ScanDisk fixes bad sectors, query on the following words in the Microsoft Knowledge Base:

how and scandisk and fixes and bad and sectors



Additional query words: 6.20 turn on turned off

Keywords: KB104725