Nothing to do with beta's here , just my arduino scratchpad
RC 1/14 Scale Range Rover
To Do
Create arduino basic framework code (define pin I/O)- 21/7/11- Bluetooth RS232 module
- Connect Bluetooth RS232 module to pins 0(RX) , 1 (TX) ,+5v(power) , GND
- Solder in headers ontop of relay shield for better access to pins
- Relay Shield
Connections to be made to Com & N/o (N/C is connected when pin is LOW)- 21/7/11 used old floppy drive power cable and molex- Set pin HIGH to turn ON relay , pin LOW to turn OFF
Run standard timed relay test code, on for 1s, off for 1s-21/7/11 , supprised at the build quality, no solder splashes and everything fits in the headers- Motor shield
- Again run standard motor tests
- Intergrate relay and motor shield code
