User:Dans34/Sandbox/arduino: Difference between revisions

From BetaArchive Wiki
Line 11: Line 11:
: <s>Connections to be made to Com & N/o (N/C is connected when pin is LOW)</s>- 21/7/11 used old floppy drive power cable and molex
: <s>Connections to be made to Com & N/o (N/C is connected when pin is LOW)</s>- 21/7/11 used old floppy drive power cable and molex
:Set pin HIGH to turn ON relay , pin LOW to turn OFF
:Set pin HIGH to turn ON relay , pin LOW to turn OFF
: <s>Run standard timed relay test code, on for 1s, off for 1s</s> -21/7/11 , supprised at the build quality, no solder splashes and everything fits in the headers  
: <s>Run standard timed relay test code, on for 1s, off for 1s</s> -21/7/11 , surprised at the build quality, no solder splashes and everything fits in the headers  
;Motor shield  
;Motor shield  
: Again run standard motor tests  
: Again run standard motor tests  
;Intergrate relay and motor shield code
;Intergrate relay and motor shield code
;Camera
:Create Roof rack for camera (use old caddy from sun server)
: Mount Wireless Video Transmitter
: BNC(camera) to RCA(transmitter) converter
: Step up 7.4v to 12v for camera
: Step up 7.4v to 9v for transmitter
: ( or will it be better to step down 12v to 9v & 12v to 5V (for arduino) ?? )

Revision as of 10:06, 22 July 2011

Nothing to do with beta's here , just my arduino scratchpad

RC 1/14 Scale Range Rover

To Do

Create arduino basic framework code (define pin I/O) - 21/7/11
Bluetooth RS232 module
Connect Bluetooth RS232 module to pins 0(RX) , 1 (TX) ,+5v(power) , GND
Solder in headers ontop of relay shield for better access to pins
Relay Shield
Connections to be made to Com & N/o (N/C is connected when pin is LOW)- 21/7/11 used old floppy drive power cable and molex
Set pin HIGH to turn ON relay , pin LOW to turn OFF
Run standard timed relay test code, on for 1s, off for 1s -21/7/11 , surprised at the build quality, no solder splashes and everything fits in the headers
Motor shield
Again run standard motor tests
Intergrate relay and motor shield code
Camera
Create Roof rack for camera (use old caddy from sun server)
Mount Wireless Video Transmitter
BNC(camera) to RCA(transmitter) converter
Step up 7.4v to 12v for camera
Step up 7.4v to 9v for transmitter
( or will it be better to step down 12v to 9v & 12v to 5V (for arduino) ?? )