Article ID: 93174
Article Last Modified on 9/30/2003
APPLIES TO
- Microsoft CodeView 3.06
- Microsoft CodeView 3.07
- Microsoft CodeView 4.0
- Microsoft CodeView 4.01
This article was previously published under Q93174
SYMPTOMS
When CodeView for Windows (CVW) is running in version 3.1 of the Microsoft Windows graphical environment, CVW does not trace into the subprograms of an application written in FORTRAN and compiled as a QuickWin application. The Step Into key (F8) acts as a Step Over (F10) and skips to the instruction that follows the current routine.
RESOLUTION
Place a break point in the desired subprogram and continue execution. CodeView halts execution at the breakpoint as desired.
STATUS
Microsoft has confirmed this to be a problem in CodeView versions 3.06, 3.07, 4.0, and 4.01 for Windows. This problem was corrected in CodeView version 4.1 for Windows.
MORE INFORMATION
In the sample code below, select the print statement and press the F9 key to set a break point. Use the F10 key to step through the code. CodeView stops on the print statement in the sub1 subprogram.
Sample Code
C -------------------------------------- C compile options: /MW /Od /Zi C -------------------------------------- call sub1() end subroutine sub1() print *,'Inside sub1' end
Additional query words: 4.00
Keywords: kbbug kbfix kb16bitonly KB93174